vroland / MyoBridge
A high-level Arduino library and custom firmware for the HM-11 (CC2541 SoC) to enable direct Myo Armband and Arduino communication.
☆80Updated 5 years ago
Alternatives and similar repositories for MyoBridge:
Users that are interested in MyoBridge are comparing it to the libraries listed below
- The BLE specification of the Myo armband☆137Updated 4 years ago
- Direct bluetooth connection between Linux and Myo armband using Bluegiga BGAPI/BGLib☆49Updated 8 years ago
- This library provides gesture detection functionality using almost exclusively the IMU data of the Myo Armband.☆30Updated 9 years ago
- ☆222Updated 7 years ago
- Replacement for MyoConnect on linux without the official Myo dongle.☆19Updated 4 years ago
- A list of all third party code written for the Myo armband☆108Updated 8 years ago
- Example code and PCB design files for the MPU-9105, 9DOF.☆132Updated 8 years ago
- Python bindings for the Myo SDK☆265Updated 3 years ago
- Access data from Thalmic Labs' Myo Gesture Control Armband in m-code!☆33Updated 2 years ago
- Contributed library to use multiple Myo's in Processing.☆51Updated 8 years ago
- Example code and board files for MPR121 Breakout board☆29Updated 6 years ago
- MyoConnect alternative for the Myo Armband with OSC protocol☆23Updated 5 years ago
- Python module to get data from a Myo armband using a generic BLE interface☆24Updated 2 years ago
- Combination of MPU-9250 and BMP180, I2C device selectable.☆34Updated 3 weeks ago
- This is the Arduino version of the code for my balancing robot/segway☆75Updated 11 years ago
- Library for the TLC5940☆25Updated 6 years ago
- ☆17Updated 4 years ago
- Inertial Motion Capture for everyone☆105Updated 2 years ago
- an open multi-touch tracker based on mutual capacitance sensing☆48Updated 4 years ago
- Teensy3.2 (32 bit ARM Cortex-M4) configs AD5930 to output 100KHz sine wave☆12Updated 7 years ago
- Arduino library for servo easing☆73Updated 2 years ago
- Arduino Library for Adafruit LIS3DH breakout board☆72Updated 6 months ago
- openEMSstim: open-hardware module to adjust the intensity of EMS/TENS stimulators.☆137Updated 3 years ago
- The Myo MATLAB data streaming interface relies on real time data read from the text files updated by Python. Python is used to communicat…☆19Updated 9 years ago
- Simple Capacitive Sensing for Arduino and AVR microcontrollers☆37Updated 12 years ago
- A simple editor for ESP code that runs inside the PDE☆20Updated 8 years ago
- ☆67Updated 6 years ago
- Code for getting the XeThru Radar to work on Arduino☆29Updated 4 years ago
- Raspberry Pi Camera Module Multiplexer☆77Updated 5 years ago
- Captures EMG signals from GForcePro and play sound according to individual channel signal.☆15Updated 8 months ago