Alternatives and similar repositories for pivoyager-firmware:

Users that are interested in pivoyager-firmware are comparing it to the libraries listed below

• sparkfun / Qwiic_OpenLog
  Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.
  ☆24Updated last year
• MitchBradley / Esp32PrinterController
  PCB design for 3D printer controller using ESP32 processor
  ☆12Updated 3 years ago
• IOT-MCU / LoRa-Radio-Node-v1.0
  datasheet and Arduino demo code for LoRa Radio Node v1.0
  ☆48Updated 6 years ago
• ttnmapper / ttntrackernode
  GPS Tracker device
  ☆13Updated 3 years ago
• rocketscream / MiniUltraLoRaWAN
  Arduino compatible single cell ultra low power LoRaWAN node
  ☆22Updated 6 years ago
• bertrik / ElectronicLoad
  Arduino software for an electronically controlled load, based on a STM32 microcontroller
  ☆21Updated 4 years ago
• xoseperez / ttgo-beam-tracker
  TTN tracker based on TTGO T-Beam hardware
  ☆28Updated last year
• wemos / LOLIN_OLED_I2C_Button_Library
  ☆15Updated 3 years ago
• gavinlyonsrepo / Cap_meter_arduino
  Capacitance meter, Arduino-based, three tests , range 18pf to 4F , Push Button input , OLED and serial monitor output.
  ☆17Updated last year
• hallard / ESP-1ch-Gateway
  1-channel gateway based on ESP8266 mcu
  ☆34Updated 7 years ago
• viperet / esp8266-power-monitor
  DIY Power Monitor project using PZEM-004T module and ESP-12F
  ☆18Updated 2 years ago
• xorbit / wesp32-demos
  Demo projects for the wESP32 board in different development environments
  ☆22Updated 9 months ago
• jimparis / esptool-ftdi
  esptool.py wrapper for FTDI devices to use RTS/CTS instead of RTS/DTR
  ☆36Updated last week
• Zanduino / INA226
  Arduino library for INA226. Deprecated, see link for new library
  ☆18Updated 6 years ago
• GravCorp / DayOLED_SSD1306
  A library for the Arduino Due, for using SSD1306 OLED screens, with DMA for high speed.
  ☆40Updated 10 years ago
• upiir / 1602_oled_character_display
  Simple design for 16x2 OLED Character Display using the US2066 chip
  ☆12Updated 2 years ago
• AdamWelchUK / PWM85
  An ATTiny version of Julian Iletts PWM5 Solar Charge Controller
  ☆49Updated 4 years ago
• nootropicdesign / samd21-lora-gps
  SAMD21 Development Board with LoRa and GPS
  ☆36Updated 6 years ago
• RalphBacon / ESP32-Dual-Core-Programming
  Absolute Beginners' Guide to programming the ESP32 with dual cores + speed test
  ☆26Updated 5 years ago
• hallard / Battery-Voltage-Measure
  Battery Voltage monitor with no current drain breakout board
  ☆71Updated 7 years ago
• RalphBacon / ATTiny85_Fuse_Resetter
  Want to use all SIX GPIO pins on the ATTiny85? Now you can.
  ☆17Updated 6 years ago
• riccibitti / CloudMyIp
  Know your router public IP address, from anywhere. Great for cheap routers or IP cameras.
  ☆39Updated 8 years ago
• technoblogy / continuity-tester
  A simple continuity tester, based on an ATtiny85 and a piezo buzzer.
  ☆18Updated 7 years ago
• rayshobby / RFToy
  Arduino library and example code for RFToy -- an Arduino-compatible gadget for RF modules. Check http://rftoy.rayshobby.net.
  ☆32Updated 10 years ago
• pkarsy / rcCalibrator
  Calibration of the internal RC oscillator of atmega328p chip, and UART bootloader(ATmegaBOOT) without crystal.
  ☆21Updated last year
• wemos / Arduino_XI
  Arduino core for WEMOS XI Boards
  ☆42Updated 6 years ago
• TheNitek / WeMos-Lora
  ESP8266 WeMos Micro Shield for HopeRF RFM95 RFM96 RFM98 Lora module
  ☆15Updated 8 years ago
• fmeschia / esr-meter
  Arduino-based battery internal resistance meter
  ☆46Updated 8 years ago
• spielhuus / LoRa-Environmental-Sensors
  ATtiny85 based LoRa atmospheric sensor board with BME280
  ☆28Updated 6 years ago
• Megunolink / MLP
  Arduino library for sending data to MegunoLink visualisers and useful components
  ☆46Updated 5 months ago