glidernet / diy-tracker
Do-it-Yourself OGN Tracker software
☆28Updated 6 years ago
Alternatives and similar repositories for diy-tracker
Users that are interested in diy-tracker are comparing it to the libraries listed below
Sorting:
- Example code for RAK811 nodes with GPS on board, transmitting their coordinates in the payload of the LoRaWAN packet in a format that is …☆14Updated 3 years ago
- RAKwireless,RAK811,BreakBoard,GPS tracker,Low power,Open source☆5Updated 3 years ago
- OGN Tracker implementation on ESP32 devices☆61Updated last year
- Collection of sketches using the Arduino core for Murata's CMWX1ZZABZ (STM32L082 and SX1276)☆100Updated last year
- demo programs for STM32L151 on the Rak811 tracker☆16Updated 6 years ago
- FSK 1200bps modem using a TCM3105☆23Updated 9 years ago
- Standalone Ultrasonic Anemometer based on a PIC32☆39Updated 7 years ago
- SAMD21 Development Board with LoRa and GPS☆36Updated 6 years ago
- Example code for end devices with GPSes on board, transmitting their coordinates in the payload of the LoRaWAN packet in a format that is…☆22Updated 3 years ago
- Backplane to connect an iC880A-SPI concentrator board to a Raspberry Pi, with protection against reversed power supply and voltage spikes…☆15Updated 5 years ago
- Teensy based ultrasound detector (Bat detector)☆18Updated 10 months ago
- Si5351 based antenna analyser using ESP32 or Arduino☆12Updated 6 years ago
- Open Glider Network Receiver based on TTGO T-Beam ESP32 hardware.☆1Updated 3 years ago
- 1-channel gateway based on ESP8266 mcu☆34Updated 7 years ago
- Breakouts for ESP8266 and ESP32 WiFi/WLAN + Bluetooth modules from Espressif (ESP-WROOM-02, ESP-WROOM-32)☆35Updated 6 years ago
- Nordic nRF905 , OGN tracker and PilotAware (SV650/Si4432) demodulators. FLARM, OGNTP and P3I decoders.☆15Updated 4 years ago
- Recovery beacon for lost UAVs☆14Updated 4 years ago
- Micro size flight controller board for Eachine E010 frame.☆28Updated 7 years ago
- Firmware for my ESP32-based hand-rolled LWIR camera device☆49Updated 7 years ago
- DIY outdoor solar harvester.☆21Updated 5 years ago
- ☆20Updated 13 years ago
- Re-write of er9x for the FS-T6 2.4GHz TX☆19Updated 4 years ago
- This library is used to connect CC2500 RF Module (Texas Instruments) with Arduino. This library is tested on Arduino UNO.☆44Updated 10 years ago
- Breakout board for LoRa all-in-one module CMWX1ZZABZ☆13Updated 5 years ago
- This repo contains all the necessary design and fabrication files for the Penguino SAMR34 RF module and its Feather breakout board.☆61Updated 4 years ago
- Kicad project for the Silver open-source, long-range camera remote control☆18Updated 5 years ago
- UKHASnet Node Firmware for various platforms - Arduino, LPC810, KL25z, ...☆11Updated 8 years ago
- Control WLToys V911/V929/V939/V949/V959 Quad Copters with Arduino☆23Updated 10 years ago
- APRS with DRA818 module☆29Updated 3 years ago
- Raspberry PI iC880A and LinkLab Lora Gateway Shield☆71Updated 4 years ago