arpruss / ADCTouchSensorLinks
capacitive touch detection without external hardware for AVR and STM32
☆43Updated last year
Alternatives and similar repositories for ADCTouchSensor
Users that are interested in ADCTouchSensor are comparing it to the libraries listed below
Sorting:
- A HID driverless bootloader and flash tool companion for the STM32F1 line☆40Updated 4 months ago
- port of free-DAP to standalone arduino☆77Updated 6 months ago
- Collection of SAMD Development Boards, Programmers, Tools and Firmware☆29Updated 3 years ago
- A library for drive a lot of GPIO chips with Arduino/Teensy3.x or LC☆71Updated 5 years ago
- Open source access to the Atmel SAMD Peripheral Touch Controller☆28Updated 8 years ago
- Adafruit TFT library using 8 bit parallel access ported to STM32☆51Updated 5 years ago
- Minimal I2C master routines for the new AVR microcontrollers.☆22Updated 3 years ago
- Fast analogRead 10/12 bit ADC for the Arduino Zero and Uno☆45Updated 9 months ago
- This library enables you to use Interrupt from Hardware Timers on an SAMD-based board. These SAMD Hardware Timers, using Interrupt, still…☆34Updated 2 years ago
- Collection of AVR Development Boards☆36Updated last year
- 2D actuator☆28Updated 6 years ago
- Enhanced version of the standard tone library☆19Updated last year
- A signal generator based on an ATtiny85 that generates a range of different waveforms☆32Updated 5 years ago
- Arbitrary waves can be drawn, edited, saved, opened and uploaded to the Due via USB, or the Due can run alone, controlled by pots & switc…☆11Updated last week
- A standalone programmer for mass-programming AVR chips☆86Updated 4 years ago
- An Arduino library for VS1053, VS1003 Codec Breakout Boards☆24Updated last year
- Tiny Arduino (and related) hacks not worth of their own repository.☆17Updated last year
- Teensy 4 sketches and such☆40Updated last year
- This library enables you to use Hardware-based PWM channels on RP2040-based boards, such as Nano_RP2040_Connect, RASPBERRY_PI_PICO, with …☆84Updated 2 years ago
- STM32H7 Arduino form factor and software compatible board☆31Updated 3 years ago
- UPDI programmer software for Arduino (targets ATtiny 417 / 814 / 816 / 817 / 1614 / 1616 / 1617 and similar MCUs)☆75Updated 3 years ago
- This is a fork from arduino/ArduinoCore-samd on GitHub. This will be used to maintain Arduino support for SAM D|L|C (M0+ and M4F) boards …☆19Updated last year
- Espressif ESP32 driving a controller-less monochrome lcd with parallel I2S bus☆67Updated 5 years ago
- Calibration of the internal RC oscillator of atmega328p chip, and UART bootloader(ATmegaBOOT) without crystal.☆21Updated last year
- Arduino sketches for use with the Dragonfly (STM32L4)☆22Updated 5 years ago
- Arduino library for the BQ27441 LiPo Fuel Gauge.☆50Updated 4 years ago
- Various STM32 boards in a form factor similar to the Maple Mini or Blue Pill board☆49Updated 6 years ago
- Arduino STM32. Hardware files to support STM32 boards, on Arduino IDE 1.8.x including LeafLabs Maple and other generic STM32F103 and STM3…☆39Updated 3 months ago
- I2S Arduino Library for STM32 Microcontrollers☆23Updated last month
- A QTouch-compatible library☆44Updated last year