antoineleclair / avr-nrf24l01Links
A library for using the nRF24L01+ with AVR chips like the ATmega328, written in C.
☆45Updated 11 years ago
Alternatives and similar repositories for avr-nrf24l01
Users that are interested in avr-nrf24l01 are comparing it to the libraries listed below
Sorting:
- PC tool for uplading hexfiles to the STM8 microcontroller via UART or SPI , using the built-in ROM bootloader. Works under Windows and Po…☆85Updated 10 months ago
- Lightweight millisecond tracking library☆44Updated 2 years ago
- Minimal I2C master routines for all AVR microcontrollers.☆174Updated 2 years ago
- A fast Arduino IDE compatible graphics and fonts library including a driver for the ILI9341 based TFT displays.☆118Updated 3 years ago
- Arduino Bootloader to Flash from SD Card☆134Updated 2 years ago
- USI based TWI/I2C library for Arduino☆60Updated 5 years ago
- Arduino hardware SPI library for ATtiny44/84, 45/85, 461/861, 2313/4313.☆159Updated 7 years ago
- Simple SSD1306 library for AVR microcontrollers.☆83Updated 8 years ago
- Atmel/Microchip ATmega328PB support for Arduino IDE☆78Updated 2 years ago
- Arduino-based solution for programming PIC microcontrollers.☆72Updated 4 years ago
- Senior project stepper motor controller based on L297, L298, ATTiny2313☆65Updated last year
- This is the fast avr programmer for AVR MCUs based on cheap stm32f103c8t6 board with usb-to-serial support.☆102Updated last month
- 7.2MHz logic analyzer speaking the SUMP protocol for the stm32f103☆90Updated 4 years ago
- There are two 'versions' of the LCD library - one is straightup avr-gcc and the other is an Arduino Library. They're essentially the same…☆109Updated last year
- STM8S SPL for SDCC☆53Updated last year
- Arduino library for read/write access to SPI flash memory chips☆178Updated 4 years ago
- SPI library for Arduino AVR and STM32F1 to connect to ESP8266☆63Updated 4 years ago
- UPDI programmer software for Arduino (targets ATtiny 417 / 814 / 816 / 817 / 1614 / 1616 / 1617 and similar MCUs)☆76Updated 3 years ago
- Modification of USBasp firmware to support UART debugging.☆63Updated 5 years ago
- Serial bootloader for STM8 microcontrollers☆97Updated 6 months ago
- Bare ATmega 8/168/328 microcontrollers with the Arduino IDE.☆84Updated 5 years ago
- Little Wire is multi-featured USB controlled open source hardware tool packed in a minimal form factor designed by ihsan Kehribar.☆102Updated 8 years ago
- ☆40Updated 10 years ago
- STM32F103 based minimalist oscilloscope.☆191Updated 7 years ago
- Tiny peripheral library for STM8 microcontrolles☆125Updated 2 years ago
- Example codes using sdcc to target STM8S MCUs.☆46Updated 5 years ago
- Generic implementation of Arduino for STM32 boards☆122Updated 3 years ago
- Library for OLED-displays runs on AVR☆131Updated 2 years ago
- A fast driver for ST7735 displays that works with Arduino's /All Teensy's/ESP8266/SPARK☆69Updated 2 years ago
- Arduino software programmer sketch, supporting ISP, HVSP, and HVPP☆71Updated last year