TheDIYGuy999 / Rc_Engine_Sound_ESP32
Allows to play vehicle engine sounds on an ESP32. Additional sounds can play in parallel with the engine sound! Controls your lights as well. compatible with SBUS, IBUS, PWM, PPM and SUMD signals.
☆296Updated 3 weeks ago
Related projects: ⓘ
- An Atmega328P based 2.4GHz receiver with integrated TB6612FNG motor driver. PWM and SBUS outputs.☆141Updated 7 months ago
- Allows to play vehicle engine sounds on Arduino☆92Updated last year
- Arduino library for RC IBUS protocol - servo (receive) and sensors/telemetry (send) using hardware UART☆199Updated last month
- An Arduino 2.4GHz and IR remote controller with OLED display☆130Updated 2 years ago
- CG scale for F3X gliders☆92Updated 6 months ago
- Arduino based RC transmitter for ELRS external TX Module☆16Updated this week
- Arduino Telemetry for the RC world☆168Updated last year
- Multi Sensor for RC with RP2040 - FrSky D, SmartPort, XBUS, SRXL, IBUS, SBUS, Multiplex Sensor Bus, Jeti Ex Bus, Hitec☆169Updated 3 weeks ago
- Control just about anything RC☆60Updated 9 months ago
- ESP32 based WiFi throttle for DCC++☆16Updated last month
- ☆202Updated 2 years ago
- Kiln PID controller based on Espressif Systems ESP32 chip board with Arduino IDE.☆107Updated 5 months ago
- Schwerpunktwaage☆47Updated last year
- Arduino as SBUS to PWM decoder☆64Updated 10 months ago
- 14 channels FW modifications for FlySky I6☆285Updated 3 years ago
- version of openXsensor to be used on raspberry pi pico RP2040 (more protocols, more functionalities)☆86Updated last month
- Deluxe OSD 5.8GHz (rx5808 module) control based on minimOSD Ardunino board☆111Updated 8 years ago
- Espressif based flight controller for hobbyist☆222Updated last week
- Arduino project to upgrade cheap Hobbyking HK-T6A or Flysky FS-CT6B transmitters or any other old RC TX☆59Updated 6 years ago
- Arduino based RC transmitter for ELRS external TX Module☆187Updated last year
- Cheap DIY RC link based on LoRa 868MHz modules☆115Updated 5 years ago
- ☆36Updated 10 years ago
- ☆15Updated 4 years ago
- The Next Step ...☆66Updated 2 months ago
- Print wirelessly from Cura, PrusaSlicer or Slic3r to your 3D printer connected to an ESP8266 or ESP32 module☆352Updated last year
- Firmware upgrade for Quanum Cyclops FPV googles that adds support for manual channel selection, external display and battery level alarm.☆45Updated 4 years ago
- DIY bluetooth obd2 gauge with ESP32☆161Updated this week
- Arduino library that allows for emulation sensors for iBUStelemetry☆30Updated 6 years ago
- ESP32 diversity video receiver - https://discord.gg/gG2sjjK☆85Updated 3 years ago
- 6 channel RC input for Arduino☆20Updated 8 years ago