Alternatives and similar repositories for python-socketcan-monitor:

Users that are interested in python-socketcan-monitor are comparing it to the libraries listed below

• HackingThings / CAN-Bus-Arduino-Tool
  A tool for performing replay and sniffing CAN bus traffic.
  ☆39Updated 4 years ago
• P1kachu / talking-with-cars
  CAN analysis - Use your car as a gamepad!
  ☆116Updated 3 years ago
• ohjeongwook / CanBusHacker
  ☆29Updated 4 years ago
• james-tate / IEBusAnalyzer
  ☆22Updated 3 years ago
• collin80 / M2RET
  GVRET fork to Macchina M2 board
  ☆73Updated 4 years ago
• Gutenshit / CANBadger
  CANBadger - Hardware & Firmware Repository - An open-source automotive security research platform.
  ☆62Updated 3 years ago
• zombieCraig / c0f
  CAN of Fingers (c0f) creates passive fingerprints of Make and Model over CAN bus
  ☆86Updated 9 years ago
• henryk / ctk
  CRC Tool Kit
  ☆18Updated 12 years ago
• ericbarch / rfid-spoofing
  RFID spoofing code from scanlime.org
  ☆19Updated 12 years ago
• sirusdv / linear_dx
  ☆10Updated 7 years ago
• nccgroup / BLEBoy
  BLEBoy is a training tool to teach users about BLE security by providing a single BLE peripheral that can be used to experiment with each…
  ☆41Updated 5 years ago
• aueb / automotivesec
  ☆26Updated 2 years ago
• cyphunk / NANDDump
  dump NAND FLASH memory chips
  ☆47Updated 8 years ago
• salmg / AudioSpoof
  Magnetic stripe spoofer implementing audio waves.
  ☆37Updated 8 years ago
• aarossig / can-joystick
  A simple utility to create a uinput joystick from the CAN bus of a vehicle.
  ☆16Updated 5 years ago
• RamiroPareja / FaultInjectionTutorial
  This is the code for the fault injection tutorial I wrote. Read the README for more information.
  ☆13Updated 10 years ago
• bmaia / lzma-unpacker
  Extract LZMA sections from cable modem firmware images
  ☆20Updated 11 years ago
• AdamLaurie / hdmi-rip
  ☆36Updated 8 years ago
• gijsh / rhme2_writeups
  Writeups for the RHME2 CTF
  ☆11Updated 7 years ago
• openvehicles / CAN-RE-Tool
  A reverse engineering tool for systems based on CAN bus communications
  ☆79Updated 3 years ago
• manux81 / canspy
  Very simple tool for users who need to interface with a device based on CAN (CAN/CANopen/J1939/NMEA2000/DeviceNet) such as motors, sensor…
  ☆55Updated 8 years ago
• nccgroup / BLESuite-CLI
  BLESuite_CLI is a command line tool to enable an easier way to test Bluetooth Low Energy (BLE) devices
  ☆32Updated 8 years ago
• sogeti-esec-lab / HomePlugPWN
  HomePlugAV tools to test PLC (in)security
  ☆46Updated 5 years ago
• gyaresu / rf1101se-teensy
  Driving one of those cheap RF1101SE boards with a Arduino or Teensy
  ☆59Updated 7 years ago
• DigitalSecurity / raspjack
  Raspberry Pi 2+ MouseJack port for SPI connected NRF24 modules.
  ☆21Updated 8 years ago
• inguardians / zigbee_tools
  A few ZigBee Tools to compliment KillerBee
  ☆52Updated 8 years ago
• zombieCraig / caringcaribou
  A friendly car security exploration tool
  ☆24Updated 9 years ago
• dalmoz / sonoff-evil
  sonoff evil firmware PoC - used for demonstration during live demo on exploitation by MQTT
  ☆16Updated 7 years ago
• J-Run / mf_nonce_brute
  1st phase of mifare classic nested auth key recovery
  ☆23Updated 6 years ago
• InteliSecureLabs / iClassReader
  Improved version. Based off original CopyClass Code From Meriac http://www.openpcd.org/HID_iClass_demystified
  ☆28Updated 10 years ago