MarlinFirmware / Trinamic_TMC2130
Arduino-compatible library to configure the Trinamic TMC2130 stepper motor driver
☆8Updated last year
Alternatives and similar repositories for Trinamic_TMC2130
Users that are interested in Trinamic_TMC2130 are comparing it to the libraries listed below
Sorting:
- SMuFF Hardware Interface Firmware☆10Updated 5 years ago
- Firmware for Replicape☆36Updated 2 years ago
- Linux distro for 3D-printers☆28Updated last year
- This is a port of GRBL 1.1 to STM32F103 target☆9Updated 8 years ago
- Marlin-based Laser Cutter/Engraver firmware for RepRap Hardware ( Marlin 1.0.0 )☆29Updated 9 years ago
- Better webUI for Smoothieware☆22Updated 8 years ago
- A 3D printer board using a powerfull STM32 MCU, TMC5160/TMC2160 driver and a Raspberry Pi or compatible SBC☆39Updated 5 years ago
- Source files for the Rostock MAX Delta 3D Printer by SeeMeCNC☆38Updated 4 years ago
- Firmware for TFT control panel for Duet electronics☆40Updated 5 years ago
- A ful metal CoreXY system for 3D printer, mill etc..☆47Updated 11 years ago
- Firmware for Nextion 2.4", 2.8", 3.2'', 4.3" (for Marlin Kimbra)☆14Updated 4 years ago
- MKS SGEN is a powerful 32-bit 3D printer control board with LPC1769. Support Marlin2.0, Smoothieware. Support MKS LCD12864 and MKS TFT To…☆40Updated 4 years ago
- Kossel 250 V-Slot☆40Updated 7 years ago
- Open Air, Medium Format, Moving Bed, FDM 3D Printer with Direct Drive Extrusion System☆19Updated 3 years ago
- An arduino based adapter to drive a 20x4 line parallel or i2c panel from smoothieware☆23Updated 8 years ago
- The 32-bit next generation of RAMBo☆24Updated 5 years ago
- An Open Source ATMEGA2560 based 3D printer controller board.☆23Updated 6 years ago
- http://hackaday.io/project/156697☆11Updated 6 years ago
- Mini Delta Bootloader☆25Updated 5 years ago
- Arduino-compatible library to configure the Trinamic TMC2130 stepper motor driver☆42Updated 7 years ago
- Configuration: CFG/SPI microsteps: Up to 1/256 microPlyer: 1/256 Logic Voltage VI0: 3-5V Motor Voltage : 5.5-46V Motor Phase Current…☆14Updated 6 years ago
- 3D printable hobby lathe☆66Updated 13 years ago
- ☆58Updated 5 years ago
- TinyBoy 2 Data Source☆19Updated 7 years ago
- Setup for DUE with RADDS and Graphical LCD☆10Updated 6 years ago
- CorEssentials is an open source corexy 3D printer.☆26Updated 3 years ago
- ☆15Updated 5 years ago
- An Arduino Shield for 3D printers☆18Updated 5 years ago
- forked from ultimachine/Ramps 1.4☆64Updated 11 years ago
- Configuration:CFG microsteps: Up to 1/256 microPlyer: 1/256 Logic Voltage VI0: 3-5V Motor Voltage : 5.5-46V Motor Phase Current: 1.2…☆15Updated 6 years ago